The Firing Line Forums - View Single Post

denster · January 13, 2011, 02:14 PM

If you have a drill press just chuck the bushing in the chuck and put a piece of medium grit paper on the table. Run the drill about 600rpm and lower the bushing onto the paper. Careful though as it only takes a touch to remove .001.

January 13, 2011, 02:14 PM	#11
denster Senior Member Join Date: April 24, 2010 Location: Ohio Posts: 581	If you have a drill press just chuck the bushing in the chuck and put a piece of medium grit paper on the table. Run the drill about 600rpm and lower the bushing onto the paper. Careful though as it only takes a touch to remove .001.