The Firing Line Forums - View Single Post - Mini-Mill for shop

Gunplummer · July 24, 2013, 02:33 PM

Not bad for a grand. At this point in life I don't need to start up again. When I was doing a lot of work yet, I always had my eye out for a small table shaper. Never came across one. Boy are they the cats #$% for gun work.

July 24, 2013, 02:33 PM	#4
Gunplummer Senior Member Join Date: March 11, 2010 Location: South East Pa. Posts: 3,364	Not bad for a grand. At this point in life I don't need to start up again. When I was doing a lot of work yet, I always had my eye out for a small table shaper. Never came across one. Boy are they the cats #$% for gun work.