|
when the shellplate index's does it stop at the detents?
if the shellplate is not advancing far enough to settle into the detents then the pawls need to be adjusted
if the shellplate is reaching the detents then there is something else going on
is the shellplate tight?
is there dirt, gunpowder, or anything under the shellplate preventing it from properly indexing?
which shellplate are you using for 45acp i know the information says either a #1 or a #45 will work with 45acp but, the #1 is somewhat problematic, the #45 works much much better
is this alignment problem happening on every case or occasionally?
i find it hard to believe that the pawls would be out on a brand new press, i guess it is not impossible but i would check everything else first
good luck, hope this helps, keep us posted
|