View Single Post
Old September 13, 2000, 08:37 PM   #2
EQP
Senior Member
 
Join Date: March 31, 2000
Location: Schaumburg, IL
Posts: 154
Mylhouse,

I load my 230grn. with a OAL of 1.240" - 1.242" and they feed perfectly every time in a variety of firearms. I also load using a RL550B. Adjust your seating die a little bit and run 5 or so cases back through the seating and taper crimp die again. Test cycle through your Kimber. Repeat until you get to the correct OAL for reliable feeding. I would not go any deeper than 1.235 just to be on the safe side due to the potential for excessive pressure buildup.

Hope that helps,
Evan
EQP is offline  
 
Page generated in 0.03280 seconds with 8 queries