View Single Post
Old February 29, 2012, 10:06 PM   #6
mykeal
Senior Member
 
Join Date: October 8, 2006
Location: Northern Michigan
Posts: 2,772
Early T/C flintlocks had a geometry problem; the hammer doesn't present the flint at the right angle. This can be solved two ways: remove, heat and bend the hammer or call Thompson Center and ask for a new lock. They will replace it at no cost.

Changing the bevel may solve the problem but flint life will be affected.
mykeal is offline  
 
Page generated in 0.03431 seconds with 8 queries