View Single Post
Old April 1, 2013, 10:23 AM   #863
Sevens
Senior Member
 
Join Date: July 28, 2007
Location: Ohio
Posts: 11,755
Totally understandable that you didn't read the whole thread. Make that a rainy day project!

I use Lee .32 H&R Mag dies with complete success.

Worth noting is that for any straight wall handgun round (must be STRAIGHT, not tapered) you not only can use dies specified for the shorter cartridge, it is the better choice.

You can use .38 Special dies for .357 Mag, .44 Special dies for .44 Mag.
The opposite is not always true because then you have a die set up for a l-o-n-g-e-r case and your brass may not reach all the way up.

Also, make sure you visit this thread:
http://thefiringline.com/forums/showthread.php?t=454312
__________________
Attention Brass rats and other reloaders: I really need .327 Federal Magnum brass, no lot size too small. Tell me what caliber you need and I'll see what I have to swap. PM me and we'll discuss.
Sevens is offline  
 
Page generated in 0.03657 seconds with 8 queries