The Firing Line Forums - View Single Post

Stick_man · August 28, 2009, 02:24 PM

For your question #2, there is a good post in the Bullet Casting 101 thread (stickied) that talks about removing burrs and such from molds. It is post #24 by Illinois Coyote Hunter. Following those directions should get your molds releasing well.

I'd suggest reading the entire thread as it has answers to most of the questions that the majority of newbies would have about casting.

Good stuff!

August 28, 2009, 02:24 PM	#5
Stick_man Senior Member Join Date: October 18, 2008 Location: Salt Lake City, Utah Posts: 241	For your question #2, there is a good post in the Bullet Casting 101 thread (stickied) that talks about removing burrs and such from molds. It is post #24 by Illinois Coyote Hunter. Following those directions should get your molds releasing well. I'd suggest reading the entire thread as it has answers to most of the questions that the majority of newbies would have about casting. Good stuff!