The Firing Line Forums - View Single Post - Casting flaw (groove) in Stainless Triggerguard

Cimarron Lawman · August 1, 2008, 07:55 PM

I looked at my metric ruler and determined that the flaw is only half a millimeter deep. If I decide to sand it down, should I use emery paper or regular sandpaper? And should I apply oil or water to the paper?

August 1, 2008, 07:55 PM	#6
Cimarron Lawman Member Join Date: December 8, 2007 Posts: 53	I looked at my metric ruler and determined that the flaw is only half a millimeter deep. If I decide to sand it down, should I use emery paper or regular sandpaper? And should I apply oil or water to the paper?