View Single Post
Old May 8, 2013, 09:05 AM   #3
nbk13nw
Junior Member
 
Join Date: February 28, 2013
Posts: 7
Re: Stainless Polish

Quote:
Originally Posted by mukwah View Post
Anyone have any experience polishing a stainless revolver? What is the best method and what steps do you take? Any advice appreciated!
Where to start...?

Caswell Plating has some great info on polishing just about anything.

I have a dremel with a flexible shaft attachment for close in work and a converted variable speed bench grinder using 6" buffing wheels. One for surface prep and one for final polish.

Good compounds are a must and SS compounds are usually black (mildly aggressive) and white (final polish). Sometimes green.

With the dremel or by hand you will also find Flitz as a cheaper alternative. But surface preparation is the key. If there are surface imperfections then some 1000 - 3000 grit wet / dry speeds up the process.

I only used the sandpaper on areas that did not affect weapon function unless an area needed some love.
nbk13nw is offline  
 
Page generated in 0.02556 seconds with 8 queries