View Single Post
Old January 15, 2001, 06:59 PM   #6
Poodleshooter
Senior Member
 
Join Date: August 7, 2000
Location: Floating down the James River in VA
Posts: 2,599
I'm not sure if this is what you're looking for, but I used to use a caliper to measure diameter at the very top of the case (at the crimp). When this measure is taken in accord with the known case diameter, it should give a consistant measure of applied crimp if the case walls are of a consistent thickness.
Poodleshooter is offline  
 
Page generated in 0.02830 seconds with 8 queries