View Single Post
Old January 12, 2001, 03:30 PM   #1
SharpCdn
Member
 
Join Date: July 29, 1999
Location: Ottawa, Canada
Posts: 72
I've been reloading for a couple years now, but I always end up in the same boat when it comes to crimping. Right now all I reload is 38/357. I am using a dillon 650. I like to experiment with different bullet types/weights a lot. However, I never know if the crimp I am putting on the bullet is identical to the last time I had set up for that same bullet.

I am wondering if there is a known method for obtaining a consistent crimp after changing your dies back and forth for various types of bullets/calibres.

Is there a way to quantify an amount of crimp pressure?
SharpCdn is offline  
 
Page generated in 0.02405 seconds with 8 queries