Thread: PIF AR JIG
View Single Post
Old April 29, 2013, 10:39 AM   #1
johnwilliamson062
Junior member
 
Join Date: May 16, 2008
Posts: 9,995
PIF AR JIG

I also frequent rimfirecentral on occasion and I have noticed they have a jig going around for drilling the rear cleaning hole in a 10/22. I have been considering an 80% AR build and thought this might be a good idea. If I buy one it will be for one or maybe two lowers and then get thrown in the closet.

Of course, the ar-15 jigs are a set, costs a little more, is a little more complicated, and TFL is probably a little more open of a forum.

I was thinking to start it off with a bit of a group buy for the jig and then to keep it rolling after the original buyers are done.

Also wondering about the various jigs and their compatibility with different 80% receivers.

The two I like so far are:
http://www.ar15jigs.com/drilljigs.html
http://www.tacticalmachining.com/80-...s/80-jigs.html
johnwilliamson062 is offline  
 
Page generated in 0.02171 seconds with 8 queries