The Firing Line Forums - View Single Post

GoBoilers! · August 23, 2011, 08:40 AM

I've got the P95 with decocker/safety. If I have the safety engaged, and I ride the slide forward as it is racked, the hammer stays back too. The thing I've noticed is that the slide does not go fully forward in this case. It stops or seems to hang up about an eighth of an inch short of forwad. If I push it that last bit then the hammer drops as if I'd just decocked it. If I let the slide go forward by itself (using slide lock/release, or slingshot method) then the hammer drops immediatley as I would expect.

My P95 is pretty new and I thought maybe it just hasn't been fully broke in or maybe it needs more lube on the rails?

Anyway, more comments / suggestions on this topic are welcome. Thanks!

---
GB!

August 23, 2011, 08:40 AM	#6
GoBoilers! Member Join Date: January 21, 2009 Location: N. Indiana Posts: 21	Similar situation here too I've got the P95 with decocker/safety. If I have the safety engaged, and I ride the slide forward as it is racked, the hammer stays back too. The thing I've noticed is that the slide does not go fully forward in this case. It stops or seems to hang up about an eighth of an inch short of forwad. If I push it that last bit then the hammer drops as if I'd just decocked it. If I let the slide go forward by itself (using slide lock/release, or slingshot method) then the hammer drops immediatley as I would expect. My P95 is pretty new and I thought maybe it just hasn't been fully broke in or maybe it needs more lube on the rails? Anyway, more comments / suggestions on this topic are welcome. Thanks! --- GB!