View Single Post
Old June 3, 2014, 10:12 PM   #4
JasoninSD
Member
 
Join Date: March 21, 2006
Posts: 86
Vale,

If you are having trouble closing the bolt on a loaded round you might need to set your dies a little further down. Normally I set my die to contact the shell holder and then turn it down just a little more. I can feel the ram contact the die and then a little bit of pressure to finish the down stroke. It might be a little harder on the brass but I do not have any problems closing the bolt on a reloaded round.

I am assuming your brass is trimmed to the proper length. If the brass is too long that can cause an issue with chambering a round.

Jason
JasoninSD is offline  
 
Page generated in 0.03524 seconds with 8 queries