View Single Post
Old February 27, 2009, 08:58 PM   #6
HisSoldier
Senior Member
 
Join Date: August 9, 2007
Location: Oregoncoast
Posts: 1,793
Thanks, I also removed the magazine safety some time ago, and saw in that forum where one can add take up slack adjustment screws for both ends of the trigger pull. I really do have a nice camera now but need a photographer to show me how to do really good closeups.

I took the bolt release stamping off and found that by grinding .020" from it's face on the original angle the worn area was full faced again. Reassembly proved it to work well again. Mention was also made in the forum that releasing the bolt using the thumb release is the probably cause of the dysfunction, and that sling shotting the bolt is the answer. I question that because mine looked like the surface was hammered rather than worn.

But in spite of that I'll be sling shotting it from now on.
__________________
CNC produced 416 stainless triggers to replace the plastic triggers on Colt Mustangs, Mustang Plus II's, MK IV Government .380's and Sig P238's and P938's. Plus Colt Mustang hardened 416 guide rods, and Llama .32 and .380 recoil spring buttons, checkered nicely and blued.

Last edited by HisSoldier; February 27, 2009 at 09:16 PM.
HisSoldier is offline  
 
Page generated in 0.03720 seconds with 8 queries