VaFisher,
Thanks...I will attempt to use it!
Here's the bench after it was just finished but empty, without presses and press mounting plate/board installed:
The bench with a few presses on them (before all the rest of the stuff goes on it). Presses were first attached to mounting plate (board) then the plate attached to bench (usng the same two front holes/lag screws on each side that the top uses to attach to the bench framework to reduce # of holes drilled into benchtop and to allow for future changes without swiss-cheesing the benchtop):
NOTE: Due to the angle I was at taking the pics, the the two Lee presses on the left look larger than they actually are.
-- John D.