View Single Post
Old April 21, 2012, 10:30 AM   #16
carprivershooter
Senior Member
 
Join Date: February 16, 2008
Location: Michigan, Upper Pennsula
Posts: 396
This is from the lee web site....

"A carbide sizer inside the Carbide Factory Crimp die post-sizes the cartridge while it is crimped so every round will positively chamber freely with factory like dependability. The adjusting screw quickly and easily sets the desired amount of crimp. It is impossible to buckle the case as with a conventional bullet seating die. Trim length is not critical so this extra operation takes less time than it would if cases were trimmed and chamfered.

Revolver dies roll crimp with no limit as to the amount. A perfect taper crimp is applied to auto-loader rounds. The crimper cannot be misadjusted to make a case mouth too small to properly head-space. A firm crimp is essential for dependable and accurate ammunition. It eliminates the problems of poor ignition of slow burning magnum powders.

If you don't see your caliber listed, check out our custom services page.
from the Lee web site....."

The second paragraph refers to there revolvers dies. I reload for the 44 mag revolver and my rounds get taper crimp. but that is the die i ordered.
__________________
CarpriverShOOter
Finch, I don't like guns. Reese, Me either but if someone has to have guns I'd rather it be me. (Person of Interest).
No trees were destroyed in the posting of the this message
carprivershooter is offline  
 
Page generated in 0.04187 seconds with 8 queries