For non-shooting bore siting, try nthis...
Get a "Workmate" table vise set-up.
pad the opening and place rifle inside with bolt removed , close clamp to hold rifle.
adjust table vise/ rifle assembly to allow you to look down the bore at a corner of a house, street light, etc. Anything over 50 yds is good.
the look thru scope anmd adjust the windage to get you "zeroed" sided to side,
then adjust elevation to be above the center of your reference.
Hit a range to finalize as you should need less than 10 round.
I do this to avoid the distractions and crowds at a public range.
|