View Single Post
Old September 16, 2012, 10:50 AM   #3
ROGER4314
Senior Member
 
Join Date: May 17, 2009
Location: East Houston
Posts: 257
Regarding rifles and barrier penetration, last month, Midway ran a special on 62 grain FBI overrun bullets (projectiles) that were barrier defeating slugs. I bought a couple of hundred of them but have not loaded them yet.

My experience using .223 FMJ 55 grain bullets on steel plate is fairly extensive. Shooting at 1/4" steel plate at 100 yards, the jacket stays on the forward side of the plate and the core punches a perfect hole completely through the plate. That was mild steel and not alloy or heat treated. After seeing that, I don't see the need for special barrier defeating projectiles. The FMJ seems to do a terrific job of piercing mild steel plate.

I shoot almost all FMJ in pistols and use very few defense bullets for concealed carry. As an outdoor shooter, I shot almost every piece, part, material and product on Earth with FMJ's and know what they will do. Stay with FMJ and there won't be a need for barrier defeating bullets.

Flash

Last edited by ROGER4314; September 16, 2012 at 10:55 AM.
ROGER4314 is offline  
 
Page generated in 0.02991 seconds with 8 queries