View Single Post
Old June 5, 2013, 06:19 AM   #18
stevelyn
Senior Member
 
Join Date: May 19, 2004
Location: Fairbanksan in exile to Aleutian Hell
Posts: 2,655
I run all of my new brass through the resizer and trim them to their trim-to-length. That way I know they are all uniform and the case mouths are square.

It also simplifies things with bullet seating and crimping especially when roll crimping revolver rounds.

Then again I've always been a little OCD about my quality control.
__________________
Stop Allowing Our Schools To Be Soft Targets!
http://fastersaveslives.org/

East Moose. Wear Wolf.
stevelyn is offline  
 
Page generated in 0.03094 seconds with 8 queries