View Single Post
Old September 12, 2011, 04:43 PM   #19
5R milspec
Senior Member
 
Join Date: December 11, 2009
Location: South Carolina
Posts: 360
you have been given the answer already.the wilson gauge just shows that a fired case will no pass.and by neck sizeing only gives the same answer.so with that said you should have learned something with your post.

the lee collet has given me many times great loads for my rifels of choice to load for.wouldn't get any other die for the task.just take your time with it and run with it.there are many post on it giveing alot to learn about useing the die.the best I can give for ya is to clean it and polish the matting parts putting a little grease between them.yeah one more for ya.deprime you cases before you use the collet die.this will help you out alot.it allows you to feel the collet closeing onto the neck alot better.by being able to feel the collet closeing on the neck it will help out with the amount of pressure you put on the ram.

now with your answer and a few tips go and load some
5R milspec is offline  
 
Page generated in 0.03307 seconds with 8 queries