Thread: Bersa Question?
View Single Post
Old April 9, 2013, 07:43 AM   #8
Wreck-n-Crew
Senior Member
 
Join Date: March 8, 2013
Location: Ohio
Posts: 1,820
Quote:
I bought a Promag (1st mistake) mag for the 383. Initially it looked the same to me, but comparing them side by side the front of the Thunder mag was cut about 1/4" deeper. I filed the 383 Promag down and made it work, but it did not work well. I had to file it down to get it to lock in to the mag well of the gun. The Promag didn't work for very long before the spring started sticking down inside the mag. A Bersa factory mag might work. I have never seen one. Compare them side by side if you can. Good luck.
I bought two (non-Bersa) mags when i purchased my thunder 380 and one was smooth like butter and the other one would just not fit ir feed....took it back....got my money. It never fit correctly either.
__________________
If you ever have to use a firearm, you don't get to pick the scenario!
Wreck-n-Crew is offline  
 
Page generated in 0.03541 seconds with 8 queries