The Firing Line Forums - View Single Post

Jim Watson · June 5, 2012, 10:57 AM

Barrel vise to not skin up the barrels, frame wrench to not bend the receiver, lathe or specialty hand tools to cut the shoulder so it screws in with the sight straight up and down and trim the tenon so the cylinder gap is right.

Oh, yeah, and some knowhow.

June 5, 2012, 10:57 AM	#3
Jim Watson Senior Member Join Date: October 25, 2001 Location: Alabama Posts: 18,541	Barrel vise to not skin up the barrels, frame wrench to not bend the receiver, lathe or specialty hand tools to cut the shoulder so it screws in with the sight straight up and down and trim the tenon so the cylinder gap is right. Oh, yeah, and some knowhow.