The Firing Line Forums - View Single Post

Bob - S.C. · April 4, 2005, 08:17 PM

Edward and Mike are Correct. Always resize your new brass first. Trim to length, debur the case neck inside and out and I always debur the primer hole on the inside on new brass. Once done, you will not have to debur the inside of the primer hole on subsequent reloadings, but case trimming and deburing of the neck is ALWAYS necessary. Good Luck.

April 4, 2005, 08:17 PM	#4
Bob - S.C. Member Join Date: March 13, 2005 Location: South Carolina Posts: 19	Edward and Mike are Correct. Always resize your new brass first. Trim to length, debur the case neck inside and out and I always debur the primer hole on the inside on new brass. Once done, you will not have to debur the inside of the primer hole on subsequent reloadings, but case trimming and deburing of the neck is ALWAYS necessary. Good Luck.