The Firing Line Forums - View Single Post

CoyDog · August 14, 2001, 07:13 PM

I'm preparing some once fired Federal factory brass for reloading in 375 H&H, and after sizing I found that about half of these cases measure 2.830 or less. Max is 2.850, and the recommended trim length is 2.840.

Is there a danger of increasing pressure from loading brass that short? I'd appreciate any input on this problem.

Thanks, CoyDog

August 14, 2001, 07:13 PM	#1
CoyDog Senior Member Join Date: December 15, 2000 Location: Wyoming Posts: 163	Short Brass?? I'm preparing some once fired Federal factory brass for reloading in 375 H&H, and after sizing I found that about half of these cases measure 2.830 or less. Max is 2.850, and the recommended trim length is 2.840. Is there a danger of increasing pressure from loading brass that short? I'd appreciate any input on this problem. Thanks, CoyDog __________________ "A man's choice of weapons is a portal into his thoughts, his values, and his character."