View Single Post
Old June 19, 2012, 08:30 AM   #3
HiBC
Senior Member
 
Join Date: November 13, 2006
Posts: 8,273
There was more than one way to do it,but one practice was to shape the rear bridge to match a Remington,and drill and tap to take a Redfield Rem base.

There are a lot of old Redfield rings and bases squirreled away in old gun shops,etc.

Might be if you check into that you will get lucky.

What may be less trouble than welding/filling/redrilling the receiver would be to look at Weaver type base blank stock or modifying another
base a little bit.

I'd rather mess up and start over on the base.

Last edited by HiBC; June 19, 2012 at 08:37 AM.
HiBC is offline  
 
Page generated in 0.03363 seconds with 8 queries