no all I needed was an existing bolt to compare to, in this case it was the bolt from an enfield NO4 already in my collection. with that in hand I went to ace hardware where I determined the bolts diameter and thread size and then I just had to find a bolt of similar length. the only bolts available that met those parameters had socket heads so I took a hacksaw to the center of the bolt head and turned it into a flat head screwdriver bolt. it fits the stock perfectly. and since it's located inside the stock behind the floor plate it does nothing to diminish the appearance of the gun.
__________________
ignore my complete lack of capitalization. I still have no problem correcting your grammar.
I never said half the stuff people said I did-Albert Einstein
You can't believe everything you read on the internet-Benjamin Franklin
|