[geetarman]

The job was done by the smith at the range and he does a whole lot of work.

His reputation is pretty darn good. I don't know how the box would have shifted out of position and that is what prompted the question of maybe a different type of stock to make sure it does not happen again.

When we checked the screws before we loosened anything, they were tight.

It was only when we loosened them you could feel the action move.

I could tell there was some pressure on the stock because a dollar bill would not pass between the barrel and the stock and it was snug on the left side.

I am really trying to figure out what to do to prevent it from occurring again.