The directions on how to do it RIGHT are difficult to fully explain on a forum.
There's more to it than just "remove some screws and pop it off".
Because of the risk of damaging or "dinking" the screws and side plate, I strongly recommend investing a few bucks in Jerry Kuhnhausen's book "The S&W Double Action Revolvers: A Shop Manual".
This is a pistolsmith's reference on how to disassemble, repair, adjust, troubleshoot, fit new parts, and reassemble a S&W the RIGHT way.
Cost is around $30.00, and should be a part of every S&W owner's gear, even if you don't plan on disassembling or repairing it.
Buy a copy from Brownell's, Midway, or order from most local and internet book stores.
Next, invest a few dollars in Brownell's S&W screwdriver set. This is a screwdriver handle and 3 or 4 driver bits that are EXACT fits in S&W screws.
The RIGHT driver bits won't "dink" the screw heads like standard drivers.
Again, we can tell you HOW to take the plate off, but telling and seeing in a good book are two different things.
|