The plan, from here (in no particular order):
-Finish my new reloading bench. Swaging these bullets is putting a lot of stress on my Redding T-7 turret press. I'd prefer to get the new bench finished, so I can mount my Rock Chucker for swaging these bullets. The RC also has a better mechanical advantage, so it will take less work from the human at the handle.
-I need to decide on a finished bullet weight (or two) to stick with, so I can decide on a mold to use for consistent cores. Right now, I'm cutting cores from the lead wire and tricking up to the desired weight with #9 lead shot. I can't see the voids and graphite from the shot being good for accuracy.
NOE molds makes a multi-weight pointed soft point three-cavity mold (
412-210) that is really close to what I would want. I need to see if the owner can make me a custom mold for the exact weights I want.
-And, of course, accuracy testing.