Thread: Cleaning Hulls
View Single Post
Old December 28, 2006, 11:22 AM   #4
ILgunman
Junior Member
 
Join Date: December 22, 2006
Location: Central Illinois
Posts: 9
I am not washing them, I just don't want to chance water in them.

I have a small concrete mixer that I am tumbling them in with silica sand. It cleans the dirt and powder residue off well, but I can only leave them in about 10 minutes tops. That doesn't get the brass very clean. Any longer starts to rough the plastic. After the silica I wipe them with a rag sprayed with silicone lubricant, slicks them right up.
ILgunman is offline  
 
Page generated in 0.03563 seconds with 8 queries