View Single Post
Old September 28, 2009, 07:14 AM   #3
hornady
Senior Member
 
Join Date: April 6, 2009
Location: SWPA
Posts: 428
The very first thing I would do is get a copy of either the Lyman or RCBS cast bullet Manual. I have the Lyman but I use lyman molds. Which gives most of the loads for there bullets. The Manual will explain in detail what is needed. I am not going to go into detail. But there is quite a lot of information you will need to go along with the equipment. RCBS molds are a little more expensive than Lyman. Lee molds are a lot cheaper. And a lot of guys use them. I have in the past and just don’t care for them. But starting out. Lee Would probably be your best bet. Lyman and RCBS you are talking about. $250.00 start up. Lee with Tumble lube about $80.00. Either way I would get one of the above Manuals to get the basics down.
hornady is offline  
 
Page generated in 0.03518 seconds with 8 queries