The Firing Line Forums - View Single Post

Darthmaum · June 28, 1999, 01:34 AM

I have a SIG P228, and noticed in SIG's catalog recently that the trigger pull can be shortened by "messing with" the little screw (my term.) above the trigger, near the slide release lever.

My ?'s are: Is this advisable? Will it noticeably effect performance? Can it be done by the layperson, and if not, how much could I expect to pay, should I choose to have it done?

Any insight would be appreciated!

------------------
Janet Reno, aka "tertiary adjunct 5 of 12"... "We are BIG BROTHER. Resistance is futile, you will be assimilated..."

June 28, 1999, 01:34 AM	#1
Darthmaum Senior Member Join Date: June 23, 1999 Posts: 394	I have a SIG P228, and noticed in SIG's catalog recently that the trigger pull can be shortened by "messing with" the little screw (my term.) above the trigger, near the slide release lever. My ?'s are: Is this advisable? Will it noticeably effect performance? Can it be done by the layperson, and if not, how much could I expect to pay, should I choose to have it done? Any insight would be appreciated! ------------------ Janet Reno, aka "tertiary adjunct 5 of 12"... "We are BIG BROTHER. Resistance is futile, you will be assimilated..."