Quote:
|
The turret would not fully advance when the press handle was raised, unless the handle was snapped upward. The turret moved to within about an eighth of an inch of the next engaged position and stopped. I could twist the turret slightly and it would “pop” into place. After tinkering with the press, I found I could move the handle up rapidly and the get the turret to fully rotate. I don’t know if this is a common problem with this press design or just a problem with the press I was testing.
|
The advance is adjustable and is very easy to adjust.
It can go out of adjustment and will not index correctly if the press is short stroked (the advancing happens when the ram travels the last few inches downward).