View Single Post
Old November 27, 1999, 10:47 AM   #3
TheOtherMikey
Senior Member
 
Join Date: October 16, 1999
Location: Surprise, Arizona, USA
Posts: 171
I use Lee dies exclusively in my Dillon 550B with one exception. The dies work just fine and the price is righht. Make sure to buy carbide pistol dies.
I always use a Lee factory taper die in the final position....using the bullet seating/taper die only to seat the bullet. I had previously had some feeding problems which led me to use the taper die...no more feeding problems.
The exception is for the .223. I had big time chambering problems with my .223 reloads. I found out the problem was the dies and a fairly tight chamber. Some folks on one of the chat rooms put me on to small base dies for the .223 and I got a set of RCBS....no more problems.

Hope this helps, Mikey
TheOtherMikey is offline  
 
Page generated in 0.03203 seconds with 8 queries