The Firing Line Forums - View Single Post

pinestraw · December 11, 2005, 10:36 AM

Have H&R Model 632, nice little gun, In good shape, no cylinder play, etc. Am
curious as to the proper way to load/reload. Hammer does not have mid-cock
position, freeing cylinder to turn. Cylinder is restrained in hammer down/
hammer full cock positions. Can remove cylinder in hammer down position.
Revolver has opening in recoil plate for loading, but no loading gate. Only
way to use reloading opening is to hold hammer slightly back while inserting/
removing ammo. Anyone have any experience/suggestions?

December 11, 2005, 10:36 AM	#1
pinestraw Member Join Date: October 24, 2005 Posts: 57	H & R Model 632 Have H&R Model 632, nice little gun, In good shape, no cylinder play, etc. Am curious as to the proper way to load/reload. Hammer does not have mid-cock position, freeing cylinder to turn. Cylinder is restrained in hammer down/ hammer full cock positions. Can remove cylinder in hammer down position. Revolver has opening in recoil plate for loading, but no loading gate. Only way to use reloading opening is to hold hammer slightly back while inserting/ removing ammo. Anyone have any experience/suggestions?