Before you replace ANYTHING, read this.
I have a rifle that I bought from my wife's uncle. It is on a Sako action, chambered in .220 Swift, with a 30 inch Hart barrel, Canjar single set trigger, and is in a McMillan stock.
I looked down the bore and saw blackness right in front of the chamber--that all important throat/leade area. The rifle had actually started to keyhole bullets at 50 yards.
Now, my wife got an Outer's Foul-Out for me at Christmastime. I decided to try it out on the Swift. I installed it, following the instructions, plugged it in and let it run for 30 minutes.
I poured the solution out and removed the rod, and decided to run a tight patch through the bore first, intending to follow my normal cleaning routine afterward. I started a patch on a jag down the bore--and the rod stopped dead. Wouldn't move forward at all.
Now, I knew that I had a properly sized patch--I had used them literally hundreds of times before. With that in mind, I decided that it needed a bit of assistance. I broke out the rubber-faced mallet, and started tapping on the end of the handle.
I heard a fairly loud "CRACK!" coming from inside the barrel! The rod moved freely afterward.
What came out of the muzzle was an almost PERFECT sleeve of rock-hard carbon fouling, shot through with yellow copper streaks!!!
I ran another clean patch on the jag--it just flowed down that bore like grease on glass. I then looked into the bore, and it looked like a mirror. Best part is that the throat and leade looked almost brand new.
Try a Foul Out first. You can use it on your other guns, as well, and you might save some money.
__________________
Hiding in plain sight...
|