View Single Post
Old November 8, 2010, 03:56 PM   #13
Poodleshooter
Senior Member
 
Join Date: August 7, 2000
Location: Floating down the James River in VA
Posts: 2,599
Quote:
Hmmm. Since the case is tapered (albeit very slightly), I don't understand how you can resize just the shoulder and part of the case. It seems like the entire case would make contact with the die at the same time. What am I missing here?
The case is tapered,but so is the die. Basically the die is sitting further up, so the case can't go as far inside of it.
With partial full length sizing, the shoulder is getting pushed back, just not very much. The entire neck is getting sized as well. The area above the casehead wouldn't be getting resized.
Poodleshooter is offline  
 
Page generated in 0.02258 seconds with 8 queries