View Single Post
Old January 13, 2013, 10:47 PM   #6
Tim R
Senior Member
 
Join Date: November 30, 2004
Location: God's side of Washington State
Posts: 1,601
Well don't I feel silly. The op said m14 right there in his title....

IMR 4064 does work well in the gas guns. One little piece of advice though, don't reload brass used in the M14 or M1A more than 3 times. These rifles are extremely hard on brass. The brass gets jerked out of the chamber before all the breech pressure has bled off. With Winchester brass you might get even fewer loads. Not because Winchester brass is bad but rather because GI brass is thicker.
__________________
God Bless our Troops especially our Snipers.
Tim R is offline  
 
Page generated in 0.02528 seconds with 8 queries