[TennJed]

I am having some trouble setting up my new Lee Classic Turret. It would not align correctly while indexing. I took out the indexing rod and turret and adjusted it with a 1/4" wrench which was suggested on a video on Lee's website.

I can get it to line up, but after a few pulls (about 5 or 6) It "misses" on a die and then lines ok on the next pull.

Why can't I get it to line up on every pull?

Also what is this piece. It was loose in the packaging and I cannot find where it goes. It looks like it would fit in the turret where the indexing rod goes, but I only have one and my extra turrets did not come with one. Thanks