View Single Post
Old October 28, 2012, 08:42 PM   #108
jmortimer
Junior member
 
Join Date: January 24, 2010
Location: South West Riverside County California
Posts: 2,763
If a thread needed to die or be closed at this point,it was this one. It is like a fire starting after you thought it was all clear. Once again will use Buffalo Bore:
180 JHP 1311 fps - Glock model 20 4.6 inch barrel
180 grain LFN 1375 fps 4 inch S&W L frame Mt. Gun

.357 more energy - 10mm less energy
Some of the 10mm proponents keep mentioning "short barrels" - not sure where this myth started. The 10mm is good and makes sense, but it is at best, close to the .357 in terms of energy, less, not more. You can go over 800 ft lbs with the .357 and you can't with the 10mm in factory guns.
P.S. Here are some more facts:
155 grain Barnes TAC-XP 1401 fps - Glock Mod 20, 4.6 inch barrel
158gr. Jacketed Hollow Point = 1485 fps 4 inch S&W L frame Mt. Gun

I like the 10mm, I just think we should keep it real. .357 more gun, better sectional density, better penetration. Now let's move on. Get a Rowland 460 and I'll show you how the .41 Mag is more gun. I like the Rowland 460 as well.

Last edited by jmortimer; October 28, 2012 at 08:53 PM.
jmortimer is offline  
 
Page generated in 0.03337 seconds with 8 queries