Quote:
Originally Posted by B_Hunter
if I did too much it was ever so slightly, the flame just started to change color when pulled them off.
So next time I will not allow any flame color change or red color of the brass
|
Your method (drill with deepwell socket) was fine. Good on`ya.
Suggest next time only two things:
Just set the propane torch on the bench and hold the drill in your hand.
You can operate in the kitchen that way w/ good light.
Get some 500°
TEMPILAQ and paint a small patch ¼"
below the shoulder.
When it goes transparent upon heating the neck/shoulder well above, dump the case.
You're precisely/repeatably
done.
No guesswork