The Firing Line Forums - View Single Post

Dreaming100Straight · November 23, 2013, 07:36 PM

I couldn't use the P Board as the range was really congested and the plate cannot be used when the far field has shooters on it. I just estimated a bit more than 1/8" height and cast off and shot. I didn't do all that bad or, but I shot my average. I suppose that is alright given I wasn't at all use to the new comb and shooting conditions were rotten.

I may have done better if I had cinched the screws down better. Only at the end of the second line did I notice that the comb had dropped all the way down.

I got to get it together though. Maybe I can fine tune the stock over Weatherby's skull.

November 23, 2013, 07:36 PM	#16
Dreaming100Straight Senior Member Join Date: February 3, 2013 Posts: 1,235	I couldn't use the P Board as the range was really congested and the plate cannot be used when the far field has shooters on it. I just estimated a bit more than 1/8" height and cast off and shot. I didn't do all that bad or, but I shot my average. I suppose that is alright given I wasn't at all use to the new comb and shooting conditions were rotten. I may have done better if I had cinched the screws down better. Only at the end of the second line did I notice that the comb had dropped all the way down. I got to get it together though. Maybe I can fine tune the stock over Weatherby's skull.