View Single Post
Old December 4, 2012, 06:55 PM   #1
poline
Senior Member
 
Join Date: January 27, 2009
Location: Richmond,Va
Posts: 292
Reloading long enough to question things!

The thoughts I'm about to put down concern pistol and revolver "target rds", not self defense rds and not match rds or compeition rds. Did I mention
"Target rds"?
That said, I don't trim every case just the ones that don't fit the Lyman
case gauge, after I full case size them.
Don't clean primer pockets,unless they are reall dirty.
Don't chamfer the brass unless I had to trim it or it is really rough.
I'm now wondering, does it hurt carbide dies if you lube the brass in
and effort to make it easyer to full length size the brass?
Thanks, in advance, for any response from the forum.
poline is offline  
 
Page generated in 0.03388 seconds with 8 queries