Quote:
thanks for the info. one last question, what is the best way to tell if the scope is inline with the barrel?
|
Funny but I just posted this today on a problem that a fella was having Luepold scope.
Technically I don't set my scope to the rifle, I set the scope's reticle to the rifle.
(Canting or Clocking)
1. Level and secure the rifle. I have a stand for this. Use whatever you got !! ..
2. Set my eye relief and set on the lowest power.
3. Look through the scope and line up the verticle with a plumb line I have on the wall.
4. Tighten rings and mark the scope.
I then proceed to use my bore scope. At this time, my scope's verticlel line
better be parrellel to the verticle lines in the bore scope's matrix. Cross-hatch pattern
Be Safe !!!