View Single Post
Old December 31, 2013, 01:46 PM   #18
Rob62
Senior Member
 
Join Date: June 28, 1999
Location: Georgia, USA
Posts: 560
Happy New Year All,

Reference the question about cleaning the Quest. I am pretty meticulous about cleaning my firearms and accessories so I have never let more than about 500-1,000 rds go through the suppressor without a thorough cleaning.

It was not bad to take apart - or too dirty after this many rounds through it. I do not have anything to compare it to, but I would say that leading was moderate. There are a couple of proprietary end cap tools (at least one) needed for disassembly. And if not having to use one of these tools is a prerequisite then this suppressor may not be right for you.

As to "noise" ratings. There may be suppressors that under laboratory sound measuring equipment are X or XX percentage quieter. However having been exposed to multiple suppressors over the years its my opinion that all well built .22 suppressors are "pretty much" the same. And I know that is a VERY subjective opinion.

Regards,

Rob
__________________
NRA & NAHC Life Member

Last edited by Rob62; January 2, 2014 at 03:23 AM.
Rob62 is offline  
 
Page generated in 0.02674 seconds with 8 queries