zippy, my ClemBert Pin was made specifically for my conversion cylinder so I could very quickly remove the conversion cylinder, reload, and re-install it. It is unlikely that I'd have a chainfire with my 45 Colt reloads. I use a factory retaining pin when shooting cap-n-ball style. Thus, my comment on a potential holster issue as being the primary issue for me....but...I don't holster....yet. IF I had a holster and IF I had a hangup issue I'd probably reduce the size of the finger grip (the washer) on my ClemBert Pin. Then it would not get hung up in a holster. Your idea of using a wire type loop is interesting.
|