The Firing Line Forums - View Single Post

griz · February 13, 2005, 08:46 AM

The ring is a canalure (SP?) that is used on some factory rounds to keep the bullet from being pushed further in the case. I'm not sure why they use it since a revolver will tend to pull the bullet instead of push it back in.

February 13, 2005, 08:46 AM	#2
griz Senior Member Join Date: July 31, 2000 Location: Middle Peninsula, VA Posts: 1,588	The ring is a canalure (SP?) that is used on some factory rounds to keep the bullet from being pushed further in the case. I'm not sure why they use it since a revolver will tend to pull the bullet instead of push it back in.