View Single Post
Old March 24, 2000, 08:18 PM   #3
AL@PA
Member
 
Join Date: March 22, 2000
Posts: 24
<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by char923:
Is it burn powder or unburn powder that is spits back. You may need alittle more crimp if it is unburn powder. To help complete the burning.[/quote]

OH OH....I do not apply a crimp, I would
not know if the powder is burnt or not, I
know my face does not like it. My die set
instruction sheet states not to apply a crimp
however, I've seen somewhere a post about using a "taper" crimp die. Who makes one of
these type ? Would this apply to a 9mm as well ? I don't seem to have a problem with
them though.
AL@PA is offline  
 
Page generated in 0.03232 seconds with 8 queries