The Firing Line Forums - View Single Post - Where the heck are all the muzzle crowning tools??

**Unclenick** · September 18, 2012, 10:11 PM

Bob,

Welcome to the forum.

I Actually put 2D/sinΘ in an earlier version of the PDF file. It was pointed out to me I was thinking in radius instead of diameter.

Edit:

OK. Now I see the problem. See next post below. The copy of the file in this post is the old one. The correct one is in another post on the forum. I taken out the bad copy and put a link to the correct one in.

September 18, 2012, 10:11 PM	#14
Unclenick Staff Join Date: March 4, 2005 Location: Ohio Posts: 21,060	Bob, Welcome to the forum. I Actually put 2D/sinΘ in an earlier version of the PDF file. It was pointed out to me I was thinking in radius instead of diameter. Edit: OK. Now I see the problem. See next post below. The copy of the file in this post is the old one. The correct one is in another post on the forum. I taken out the bad copy and put a link to the correct one in. __________________ Gunsite Orange Hat Family Member CMP Certified GSM Master Instructor NRA Certified Rifle Instructor NRA Benefactor Member and Golden Eagle Last edited by Unclenick; September 21, 2012 at 11:24 AM.